4.
Remove the propeller shaft bolts(A-4ea).
Tightening torque :
49.0~68.6N.m (5.0~7.0kgf.m, 36.2~50.6lb-ft)
It is not recommended to overhaul the transfer assembly because a special three-dimensional measuring instrument is required to determine the sizes of the transfer assembly spacers when disassembling and reassembling the transfer assembly. If putting wrong sized spacers in the transfer assembly, it may cause noise and vibration.So, if inner parts of the transfer assembly need to be replaced, the transfer assembly should be replaced with new one.
Disconnect the (-) terminal from the battery.
Lift up the vehicle.
Remove the front muffler. (Refer to "Intake And Exhaust System" in EM group)
Remove the propeller shaft bolts(A-4ea).
Tightening torque :
49.0~68.6N.m (5.0~7.0kgf.m, 36.2~50.6lb-ft)
Remove the right driveshaft (passanger side) from the transfer case. (Refer to "Drive shaft assembly" in DS group)
Install the propeller shaft to be near runout marking (Transfer assembly 1ea, propeller shaft 1ea) each other.
Remove up and down mounting bolt (A, B) after removing the transfer case bracket mounting bolt (C).
Remove the transfer case with pry-bar after supporting the transfer case with a jack.
