4.
Is the measured value within specification?
 | ▶ Go to "Control signal waveform inspection" procedure. |
 | ▶ Repair 'ELECTRICAL VGT ACTUATOR' , and go to "Verification of Vehicle Repair" procedure. |
IG key OFF.
Disconnect VGT actuator connector.
Check resistance between CAN High and Low terminal of 'ELECTRICAL VGT ACTUATOR'.
Specification : 2.4 kΩ
Is the measured value within specification?
| ▶ Go to "Control signal waveform inspection" procedure. |
| ▶ Repair 'ELECTRICAL VGT ACTUATOR' , and go to "Verification of Vehicle Repair" procedure. |
IG key ON and warm engine up its temperature to be higher than 70℃.
Place oschilloscope probe at CAN High and Low terminal of VGT actuator.
Check output signal of CAN communication.
Is the measured value within specification?
| ▶ Go to "Verification of Vehicle Repair" procedure. |
| ▶ Repair 'ELECTRICAL VGT ACTUATOR' , and go to "Verification of Vehicle Repair" procedure. |
