2.
Remove the seat belt after pushing the lock pin (A).
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
Remove the seat belt after pushing the lock pin (A).
Remove the following parts. (Refer to the Body group-Interior trim)
Door scuff trim
Center pillar trim
Disconnect the Anchor Pretensioner connector.
Loosen the Anchor Pretensioner mounting bolt and remove the Anchor Pretensioner.
Remove ignition key from the vehicle.
Disconnect the negative (-) cable from battery and wait for at least three minutes.
Install the Anchor Pretensioner with a bolt.
Tightening torque
: 39.2 ~ 53.9 Nm(4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
Connect the Anchor Pretensioner connector.
Install the following parts. (Refer to the Body group - Interior trim)
Center pillar trim
Door scuff trim
Reconnect the battery negative cable.
After installing the Anchor Pretensioner, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
