3.
Install the bands to both BJ boots.
Wrap tape around the driveshaft splines (PTJ. side) to prevent damage to the boots.
Apply grease to the driveshaft and install the BJ boots.
Install the bands to both BJ boots.
Using the SST(09495-3K000), secure the boot bands.
Clearance (A) : 2.0 mm (0.079 in.) or less
To reassemble the dynamic damper, keeping the shaft in the straight, tighten the dynamic damper with dynamic damper band, as the illustration.
Distance (L) : 219.7 ± 2mm (8.64 ± 0.07in)
Install the PTJ boot bands and PTJ boot.
Install the trunion assembly (A) and the circlip (E) to the spline (C) on the driveshaft.
At this time align the marks (D) each other.
Install the clip to the PTJ case (B).
Add the specified grease to the PTJ as mush as wiped away at inspection.
Install the PTJ boots.
To control the air in the PTJ boot, keep the specified distance between the boot bands when they are tightened.
Distance (A) | LH side | RH side |
Diesel 2.2 (mm(in)) | AT : 511.6 (20.14) MT : 507.4 (19.97) | 514.6 (20.25) |
Install the bands to both PTJ boots.
