1.
Remove the circlip (B) from driveshaft splines (A) of the differential side TJ case.
Do not disassemble the BJ assembly.
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
The boot band should be replaced with a new one.
Remove the circlip (B) from driveshaft splines (A) of the differential side TJ case.
Remove the both boot clamps from the differential side TJ case.
Pull out the boot from the differential side joint(TJ).
While dividing joint(TJ) boot (A) of the differential side, wipe the grease in TJ case (B) and collect them respectively.
Be careful not to damage the boot.
According to below the illustrated, put marks (D) on roller of trunion assembly (A), TJ case (B) and spline part (C), for providing assembly.
Using a snap ring plier or flat-tipped (-) screwdriver, remove the circlip (A).
Remove the trunion assembly (B) from the driveshaft (A) using the special tool (09495-33000).
Clean the trunion assembly.
Remove the boot (A) of the transaxle side joint(TJ).
For reusing the boot (A), wrap tape (B) around the driveshaft splines (C) to protect the boot (A).
Using a plier or flat-tipped (-) screwdriver, remove the clamp on the side of wheel.
Pull out the joint(BJ) on the side of wheel into the transaxle direction.
Be carefull not to damage the boot.
