1.
Drain off oil from Rear differential carrier.
Drain off oil from Rear differential carrier.
Loosen the mounting bolts and then remove the cover.
Before disassembling differential case assembly, paint match marks on one side of the bearing cap.
Loosen the bearing cap bolts and then remove the bearing cap.
Disassemble the differential case assembly.
Mark as below removing the differential case assembly not to be changed with the left/right side of bearing race.
Remove the bearing not to be dameged after setting the bearing remover at the discape hole.
Be careful to confuse left and right side bearing.
Loosen the ring gear bolt and then remove the drive gear.
Tap drive gear off the differential case with a soft hammer.
Drive out pinion mate shaft lock pin with punch from drive gear side.
Remove the pinion mate shaft.
Remove the side gears, pinion mate gears, side gear thrust washers, pinion mate thrust washers from differential case.
Loosen the drive pinion locking nut.
Using the press, take out drive pinion (together with pinion rear bearing inner race, pinion bearing adjusting spacer) and then remove the companion flange.
Using the press, remove the pinion rear bearing.
Do not damage the pinion shaft(A).
Using the screwdriver, remove the front oil seal.
Usint the screwdriver, removt the side oil seal.
