1.
Using a screwdriver or remover, remove the delta cover (A).
When prying with a flat-tipped screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
Using a screwdriver or remover, remove the delta cover (A).
Using a screwdriver, remove the door inside handle cap (B).
Loosen the mounting screws, and then remove the door trim (A).
Push the hook (B), disconnect the inside handle cable cage (A).
Push the lock pin (A), disconnect the power window connector (B).
Remove the door trim
Installation is the reverse of removal.
Make sure connectors are connected properly and each rod is connected securely.
Make sure the door lock and opens properly.
Replace ant damaged clips.
Remove the door trim.
Loosen the mounting screws, then remove the inside handle (A).
Installation is the reverse of removal.
Make sure the door lock and opens properly.
Replace ant damaged clips.
Remove the following parts.
Door trim
Door belt weatherstrip
Door delta moulding
Remove the glass mounting plug hole.
Using the door switch to align the mounting hole with the hole on the door glass.
If it is impossible, align the hole by hand after removing the motor.
Be careful not to drop to glass and scratch the glass surface.
Carefully adjust the glass (B) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.
Tightening torque :
7.8~11.8 N.m (0.8~1.2 kgf.m, 5.8~8.7 lb-ft)
Installation is the reverse the removal.
Roll the glass up down to see if it move freely without binding
Adjust the position of the glass as needed.
Make sure the door lock and opens properly.
Replace ant damaged clips
Remove the door trim.
Drill out the rivets to remove the speaker (B) from the door module.
Disconnect the speaker connector (A).
Installation is the reverse of removal.
Use sheet metal screws to secure the speaker.
Make sure the door lock and opens properly.
Make sure the connector is connected properly.
Remove the door trim.
Disconnect the connector (A)
After loosening the mounting screws, then remove the power window motor (B).
Installation is the reverse of removal.
Grease should be applied to areas where there is rotational parts and springs.
Roll the glass up and down to see if it move freely without binding.
Make sure the door lock and opens properly.
Disconnect cap (A), loosen the mounting bolt.
Remove the handle cover (B).
Tightening torque :
7.8~11.8 N.m (0.8~1.2 kgf.m, 5.8~8.7 lb-ft)
Remove the outside handle (A), by sliding it rearward.
Installation is the reverse of removal.
Roll the glass up and down to see if it move freely without binding.
Make sure the door lock and open properly.
Remove the following parts.
Door trim
Window glass
Outside handle
Loosen the mounting screw (A).
Loosen the mounting bolts and nut, then remove the rear channel (A).
Tightening torque :
6.9~10.8 N.m (0.7~1.1 kgf.m, 5.1~8.0 lb-ft)
Loosen the door module mounting bolts and latch mounting screws
Remove the door module (A)
Tightening torque :
6.9~10.8 N.m (0.7~1.1 kgf.m, 5.1~8.0 lb-ft)
Remove the wiring mounting clip (A) and pad (B).
Disconnect the cap (A).
Push the hook, disconnect the main wiring connector (B).
Remove the door module.
Installation is the reverse of removal.
Grease should be applied to areas where there is rotational parts and springs.
Roll the glass up and down to see if it move freely without binding.
Make sure the door lock and opens properly.
