2.
Insert the special tool (09411-25000) in the clutch disc to prevent the disc from shifting.
Remove the transaxle assembly. (Refer to "Manual transaxle system" in MT group)
Insert the special tool (09411-25000) in the clutch disc to prevent the disc from shifting.
Loosen the bolts(6ea) which attach the clutch cover to the flywheel in a star pattern. Loosen the bolts in succession, one or two turns at a time, to avoid bending the cover.
Do not clean the clutch disc or the release bearing with cleaning solvent.
Find the position of the stop (A):
There is only one.
It is located on the pitch circle of cover assembly bolts between the bolt mount and the dowel pin, wedged between the cover assembly and the flywheel.
The head of the guide bolt sticks out about 3 mm from the housing.
Loosen the cover assy bolts opposite each other in increments (in approx. 5 stages), and
Check that the stop (B) loosens and slides down to the block in the housing.
The stop (B) must loosen when unscrewed from the housing (about 2mm).
If necessary, push the guide boltb (A)toward the flywheel.
Loosen the cover assy bolts and remove the clutch from the flywheel.
Place the cover assy on a clean surface.
Do not clean the clutch disc or the release bearing with cleaning solvent.
