2.
Remove the split pin and front lower arm mounting bolt from the knuckle.
Tightening torque :
100 ~ 120 N.m(10.0 ~ 12.0 Kgf.m, 72~87 lb-ft)
Remove the front wheel & tire.
Tightening torque :
90 ~ 110 N.m(9.0 ~ 11.0 Kgf.m, 65~80 lb-ft)
Remove the split pin and front lower arm mounting bolt from the knuckle.
Tightening torque :
100 ~ 120 N.m(10.0 ~ 12.0 Kgf.m, 72~87 lb-ft)
Remove the front lower arm from the front knuckle using the SST (0K545-A9100).
After removing bolts from the front knuckle, install and tighten the sub body bolt (A) .
Input the sub body (A) between the front knuckle and the sub body bolt.
Tighten bolt (B) of the sub body bolt to broaden the gap of the front knuckle.
Install the safe wire (A).
Install a safe wire on the front strut to prevent dropping the SST and hurting technicians.
Install the main body, between the front strut and the lower arm.
To avoid the main body coming off, install a fixing clamp (A) beside the main body.
After installing a fixing clamp, rotate the handle (B) clock wise till the clamp is fixed on a lower arm.
Tighten a main body bolt (A) of the slowly and remove the lower arm from the front knuckle.
Remove the lower arm mounting bolts & nuts and then remove the lower arm.
Tightening torque :
140 ~ 160 N.m(14.0 ~ 16.0 Kgf.m, 101~116 lb-ft)
Installation is the reverse of removal.
Check the bushing for wear and deterioration.
Check the lower arm for bending or breakage.
Check the ball joint dust cover for cracks.
Check all bolts.
