Disconnect the PCSV and PCM connectors and inspect for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Reconnect the connectors.

Connect the GDS and go to ""Current Data"".

Monitor PCSV values in Current Data, check and wiggle the harness(es), connector(s), and terminal(s).

Any change in the values indicates a poor connection. Was a connector problem found?

	▶ Repair the connector. Go to "Verification of Vehicle Repair" procedure.
	▶ Go to " Control Circuit Inspection " procedure.

IG "OFF". Disconnect PCSV connector.

IG "ON".

Measure voltage between control terminal of PCSV harness connector and chassis ground.

Is the measured voltage within specification ?

	▶ Go to "Component Inspection" procedure.
	▶ Repair short to battery in harness. Go to " Verification of Vehicle Repair" procedure.