4.
Maintaining ENG. RPM at 2,500RPM(idle) over 2 minutes.
Specification : more than 8.7 [V]
Fig.1) Engine ON
Connect GDS to Data Link Connector(DLC)
Start engine and turn the headights and the rear defrost on.
Monitor the "BATTERY VOLTAGEcurrentdata12345#" parameter on the GDS.
Maintaining ENG. RPM at 2,500RPM(idle) over 2 minutes.
Specification : more than 8.7 [V]
Fig.1) Engine ON
Is parameter within specifications?
 | ▶ Fault is intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and 4WD ECU memory is not cleared yet. Thoroughly check all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage. ▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to "W/Harness Inspection" procedure. |
