Monitor GDS Data
1.

Connect GDS to Data Link Connector(DLC)

2.

IG key "ON" , Engine "ON".

3.

Warm up the engine to normal operating temperature.

4.

Monitor diagnostic trouble code and present of trouble code.

5.

Are any DTCs present ?

Using a GDS, Check if the same DTC re-sets after clearing DTC.

6.

Is the same DTC detected again?

▶ Substitute with a known-good "Coupling" and check for proper operation. If the problem is corrected, replace "Coupling" and then go to "Verification of Vehicle Repair" procedure.

▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure.

▶ Go to "Component Inspection" procedure.

Яндекс.Метрика