5.
Read "DTC Status" parameter.
note
- History (Not Present) fault : DTC occurred but has been cleared.
- Present fault : DTC is occurring at present time.
Vehicle Parked & Ignition ON.
Connect GDS and select "DTC Analysis" mode.
Click "DTC Status" on the DTC menu bar to see DTC's information.
Confirm that "DTC Readiness Flag" indicates "COMPLETED". If not, drive the vehicle within conditions noted in the freeze frame data or enable conditions.
Read "DTC Status" parameter.
- History (Not Present) fault : DTC occurred but has been cleared.
- Present fault : DTC is occurring at present time.
Is parameter displayed "Present fault"?
 | ▶ Substitute with a known-good TPMS Module and check for proper operation. ▶ If the problem is corrected, replace TPMS Module and go to "Verification of vehicle Repair" procedure. ▶ After replacing with a known-good TPMS Module, you must do the 'Vehicle Name Writing', 'VIN Writing' and 'Register Sensor' at the Vehicle S/W Management mode by using GDS and GDS TPMS. |
 | ▶ This fault was repaired and TPMS Module memory was not cleared. Go to "Verification of Vehicle Repair" procedure. |
