Monitor GDS Data
1.

Connect GDS to Data Link Connector(DLC).

2.

IG key "ON", Engine "ON".

3.

Monitor diagnostic trouble code and present of trouble code.

4.

Are any DTCs present ?

Using a GDS, Check if the same DTC re-sets after clearing DTC.

▶ Go to "BSD calibration" procedure .

▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure.

5.

BSD Calibaration(EOL)

note

To complete the calibration in minimum time, if it is possible, not to use the vehicle that is stabilized for suspension

The calibration reflector should be perpendicular to the floor.

Make sure that there is no other moving material except the reflector in a space around the reflector within 1.0m(3.28ft)

The reflector should be perpendicular to the floor.

(1)

Aline wheel & steering of the vehicle on a straight the vehicle satatus

- check the bumper status, installed & surface (stciker, mud)

(2)

Check the reflector to be parallel/horizontal with a vehicle

(3)

IG-on.

(4)

Connect to GDS Scantool

(5)

Select "Vehicle S/W Management"

(6)

Perform the procedure " BSD Calibartion (EOL)"

7-1) Check the massage "calibration completed"

7-2) If the calibaration procedure is stopped, recalibration step 1 (5times)

7-3) 7-2) Incase failed the calibariton in 5times

- Check the bumper installed (surface, bumper gap)

- Check the braket installed after detachment the bumper

>. Check the location of the braket - check the guide line

>. Installed braket : check seperated fusion splicing of Supersonic waves(6 points), inserted alien substance

>. Installed ladar : check loosed the screw (3point), inserted alien substance

7-4) 7-3) after calibration failed above 5 times, replace the sensor .

Яндекс.Метрика