Component Inspection
■ Check immobilizer lamp.
1.

IG KEY OFF

2.

Connect SMARTRA connector and disconnect PCM/ECM connector

3.

Ground indicator terminal of PCM/ECM harness connector with wire

4.

IG KEY ON & Engine "OFF"

Specification : Immobilizer lamp "ON"

5.

Is the Immobilizer lamp "ON"?

▶ Substitute with a known-good PCM/ECM and check for proper operation.

If the problem is corrected, replace PCM/ECM and then go to "Verification of Vehicle Repair" procedure.

note

ECM substitued for old one must be in "Virgin" or "Neutral" status and Pin code is requied to Neutralize ECM and to Register transponder key

▶ Check that fuse has blown off and harness between PCM/ECM connector and Battery is in normal condition.

And. check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика