BSD LED switch Inspection
■ Actuator Test Check
1.

Connect GDS to Data Link Connector(DLC)

2.

IG key "ON"

3.

Perform "Actuation Test" with GDS.

4.

Is the signal changed of BSD switch in the normal range?

▶ Ggo to "Verification of Vehicle Repair" procedure.

▶ Check for open or short in the BSD switch Check a voltage of power wiring circuit.

▶ Substitute with a known-good BSD LED switch assembly and check for proper operation.

If the problem is corrected, replace BSD LED switch assembly and then go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known-good BSD ECU(LH) assembly and check for proper operation.

If the problem is corrected, replace BSD ECU(LH) assembly and then go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика