P2016 is set when variable swirl valve position sensor output voltage below 0.13V is detected for more than 2.5 sec.. This code is due to open in power circuit or short to ground in signal circuit.
Item | Detecting Condition | Possible Cause | ||
DTC Strategy |
•
Voltage monitoring | 1. Variable swirl valve position sensor circuit 2. Variable swirl valve position sensor component | ||
Enable Conditions |
•
IG key ON or engine running | |||
Threshold Value |
•
VSA Output voltage below minimum value. (below 130mV) | |||
Diagnostic Time |
•
2.5 sec. | |||
Fail Safe | Fuel cut | NO |
•
Swirl valve opened at variable swirl control actuator failure. | |
EGR Off | NO | |||
Fuel Limit | NO | |||
Check Lamp | OFF | |||
