Component Inspection
■ LP EGR Component check

-The sensor signal : 0.6V ± 0.2V (at full close), 4.4V ± 0.3V (at full open)

1.

Is the measured value within specification?

▶ Go to "Verification of Vehicle Repair" procedure.

▶ Replaces EGR actuator, and go to "Verification of Vehicle Repair" procedure.

note

In case of replacing LP EGR actuator , perform the "COMPONENT CHANGE ROUTINE" procedure with scan tool. If the "COMPONENT CHANGE ROUTINE" procedure has not completed until automatic learning completed, it may cause vehicle performance and exhaust gas problem.

Яндекс.Метрика