1.
Using a screwdriver or remover, remove the front door scuff tirm (A).
[Front]
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not to bend or scratch the trim and panels.
Using a screwdriver or remover, remove the front door scuff tirm (A).
[Front]
Disconnect the connector (A).
Using a screwdriver or remover, remove the rear door scuff tirm (A).
[Rear]
Install in the reverse order of removal.
Make sure the connector is connected properly.
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not to bend or scratch the trim and panels.
After loosening the screw, then remove the front pillar trim (A).
Install in the reverse order of removal.
Replace any damage clips.
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not to bend or scratch the trim and panels.
Remove the front door scuff trim.
Remove the hood latch release handle.
Using a screwdriver or remover, remove the cowl side trim (A).
Install in the reverse order of removal.
Replace any damage clips.
Pry the trim off using a plastic trim tool and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
Take care not to scratch the body surface.
Remove the front door scuff trim.
Remove the rear door scuff trim.
Remove the front seat belt lower anchor cover (A).
After loosening the mounting bolt, then remove the front seat belt lower anchor (B).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)
Using a screwdriver or remover, remove the center pillar lower trim (A).
After loosening the mounting bolt, then remove the center pillar upper trim (B).
Install in the reverse order of removal.
Replace any damage clips.
Pry the trim off using a plastic trim tool and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
Take care not to scratch the body surface.
Remove the rear door scuff trim.
Remove the luggage box trim (A).
Remove the luggage box partition trim (A).
After loosening the mounting screws, then remove the rear transverse trim (A).
After loosening the mounting bolt, then remove the second row seat belt lower anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)
After loosening the mounting bolt, then remove the third row seat belt lower anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)
After loosening the mounting screws, then remove the luggage side trim (A).
Install in the reverse order of removal.
Replace any damage clips.
Pry the trim off using a plastic trim tool and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
Take care not to scratch the body surface.
Remove the luggage side trim.
After loosening the mounting bolt, then remove the C pillar trim (A).
Install in the reverse order of removal.
Replace any damaged clips.
Pry the trim off using a plastic trim tool and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
Take care not to scratch the body surface.
Remove the luggage side trim.
After loosening the mounting bolt, then remove the rear pillar trim (A).
Install in the reverse order of removal.
Replace any damaged clips.
