4.
Separate the control cable from the control shaft complete after remove the pin (A) and washer (B).
Set shift lever to N position.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
Separate the control cable from the control shaft complete after remove the pin (A) and washer (B).
Remove the control shaft complete (A) after loosening the bolts.
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Removal is possible only on "N" position.
Install in the reverse order of removal.
When installing, set control shaft lever to neutral position.
When installing, apply the sealant as shown in the illustration.
Specified sealant : MS 721-40 or MS721-38
