3.
Remove the shower duct (A).
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the crash pad lower panel and reinforce panel.
(Refer to Body - "Crash pad lower panel")
Remove the shower duct (A).
Disconnect the stop lamp switch connector (A).
Remove the brake pedal member mounting nut (A).
Remove the snap pin (A) and clevis pin (B).
Remove the brake pedal member assembly mounting nuts (A) and then remove the brake pedal assembly.
Check the bushing for wear.
Check the brake pedal for bending or twisting.
Check the brake pedal return spring for damage.
Check the stop lamp switch.
Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in and when it is released.
The stop lamp switch is in good condition if there is no continuity when plunger(A) is pushed.
Pre-tighten the bracket fixing bolt (A) in dash panel.
Install the brake booster and brake pedal member fixing nuts (A) securely.
Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
Tighten the bolt (A) securely in dash panel.
Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
Install the snap pin (A) and clevis pin (B).
Before installing the pin, apply the grease to the clevis pin.
Use a new snap pin whenever installing.
Install the stop lamp switch securely.
Connect the stop lamp switch connector (A).
Adjust the brake pedal height and free play.
Check the brake pedal operation after installing the brake pedal.
Install the shower duct (A).
Install the crash pad lower panel.
Reconnect the battery negative cable.
Disconnect the stop lamp switch connector (A) and loosen the stop lamp switch lock nut.
Adjust the brake pedal height (A) as illustration below.
Pedal height : 271 mm (10.67 in)
Adjust the stop lamp switch clearance (B) and brake pedal free play.
Stop lamp clearance: 1.0 ~ 2.0 mm (0.04 ~ 0.08 in)
Pedal free play: 3.0 ~ 8.0 mm (0.12 ~ 0.31 in)
Adjust the brake pedal free play using the stop lamp switch lock nut.
Connect the stop lamp switch connector.
