1.
Remove the engine room under cover by loosening the mounting clip (A) and bolts (B).
Remove the engine room under cover by loosening the mounting clip (A) and bolts (B).
Separate the front portion of the front wheel guard from the wheel base.
(Refer to Body - "Body Side Moldings")
Remove the engine room right side cover.
Loosen the drive belt.
(Refer to Engine Mechanical System - "Drive Belt")
Remove the center bolt (A) while holding the pulley with a disc & hub bolt remover (09977-25100).
Tightening torque :
15 ~ 21 N.m (1.5 ~ 2.1 kgf.m, 11.1 ~ 15.5 lb-ft)
Loossen the hub bolts and then remove the hub assembly.
Remove the pulley (B) after removing the snap ring (A) with a snap ring plier.
Be careful not to damage the pulley and compressor during disassembly/reassembly.
Once the snap ring is removed, replace it with a new one.
Reassemble in the reverse order of disassembly.
Clean the pulley and compressor sliding surfaces with non-petroleum solvent.
Install a new snap ring, and make sure they are fully seated in the groove.
Make sure that the pulley turns smoothly after reassembly.
