5.
Remove the delivery pipe installation bolts (B).
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line")
When removing the fuel pump fuse, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
Remove the surge tank.
(Refer to Engine Mechanical System - "Intake Manifold")
Disconnect the injector [Bank 1] connector (A).
The injector [Bank 2] connector was disconnected when removing the surge tank.
Remove the delivery pipe installation bolts (B).
Remove the installation nuts (A), and then remove the delivery pipe & injector assembly from the engine.
Install in the reverse order of removal.
Delivery pipe installation bolt:
9.0 ~ 11.8 N.m (0.9 ~ 1.2 kgf.m, 6.6 ~ 8.7 lb-ft)
Delivery pipe installation nut (↔ Fuel feed tube):
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
