Install the cam carrier (A) with a new gasket (B).
Apply sealant (LOCTITE 518, THREEBOND 1389 or equivalent) to the rectangular area at the rear of the cylinder head before assembling the cam carrier.
Remove the extruded sealant after assembling cam carrier. Otherwise it can cause oil leak from the cylinder head cover.
Install the camshafts (A) with the timing marks (B,C) aligned.
When assembling the camshafts, check the front and rear timing marks on the gears.
Install the camshaft bearing caps (A).
Remove the assembly pin (B). (Standard only)
Tightening torque :
10.8 ~ 12.7 N.m (1.1 ~ 1.3 kgf.m, 8.0 ~ 9.4 lb-ft)
Fasten the bearing cap bolts in the sequence shown.
Install the other parts in the reverse order of removal.
