13521932

1.

Install the SST (09231-1M200, 09231-H110) (A) on the crankshaft.

2.

Push in the rear oil seal case assembly (B) by hand and then tighten the bolts.

Tightening torque :

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

note

●

Do not reuse the rear oil seal case assembly.

●

Apply a coat of engine oil around PTFE seal before installing the rear oil seal assembly.

●

Be careful not to damage and twist the PTFE seal.

●

When installing the rear oil seal case assembly, do not hold the lip portion.

●

Remove harmful materials on the crankshaft flange and use the SST to prevent the PTFE seal from being damaged and twisted.

●

When keeping the SST, keep away from foreign substances and be careful not to be scratched.

●

Insert the dust cover (A) completely into the slot of the cylinder block and then confirm the assembly with the sensor cable (B).

3.

Install the encoder (A).

4.

Install the other parts in the reverse order of removal.