5.
Remove the water pump pulley (A).
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Remove the RH side front wheel.
(Refer to Suspension System - "Wheel")
Remove the engine room under cover and RH side cover.
(Refer to Engine And Transaxle Assembly - "Engine Room Under Cover")
Drain engine coolant so that its level would be under the water pump height.
(Refer to Cooling System - "Coolant")
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
Remove the water pump pulley (A).
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Remove the water pump (A) with the gasket (B).
Tightening torque :
19.6 ~ 24.5 N.m (2.0 ~ 2.5 kgf.m, 14.5 ~ 18.1 lb-ft)
When installing the water pump, use a new gasket.
Remove the oil level gauge & guide assembly. (Euro 5 only)
(Refer to Lubrication System - "Oil Level Gauge & Guide")
Remove the emergency filter (A). (Euro 5 only)
Tightening torque :
19.6 ~ 24.5 N.m (2.0 ~ 2.5 kgf.m, 14.5 ~ 18.1 lb-ft)
Remove the low pressure EGR valve. (Euro 5 only)
(Refer to Engine Control/Fuel System - "Low Pressure EGR valve")
Remove the water pump cover (A) with the gasket.
Tightening torque :
19.6 ~ 24.5 N.m (2.0 ~ 2.5 kgf.m, 14.5 ~ 18.1 lb-ft)
Remove the bolts then pull the water pump cover forward from the water pipe.
When installing the water pump cover, use a new gasket.
When assembling the water pipe and the water pump cover, keep the surface of O-ring from dust and oil.
Be careful no to damage the surface of the O-ring. And apply a coat of alhorm (BW-0431) or equivalent (not engine oil).
Install in the reverse order of removal.
Fill the radiator with coolant.
(Refer to Cooling System - "Coolant")
Start engine and check for leaks.
