Remove the engine room under cover.
(Refer to Engine And Transaxle Assembly - "Engine Room Under Cover")
Drain the engine oil.
(Refer to Lubrication System - "Engine Oil")
Drain engine coolant so that its level would be under the oil cooler height.
(Refer to Cooling System - "Coolant")
Disconnect the oil cooler hoses (A).
When removing and reinstalling the oil cooler hoses, do not apply the excessive force. It may cause the coolant leakage by deformation of the cooler nipple.
Install the oil filter & cooler assembly (B).
Tightening torque :
19.6 ~ 26.5 N.m (2.0 ~ 2.7 kgf.m, 14.5 ~ 19.5 lb-ft)
When installing the oil filter & cooler assembly, check the existence of two O-rings on the mating surface to the cylinder block, and tighten the 4 upper bolts first then tighten the other lower bolt.
Remove the oil cooler (B) from the oil filter (A).
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
When installing the oil cooler, check the existence of two O-rings on the mating surface to the oil filter.
Install the other parts in the reverse order of removal.
Refill with the engine oil.
(Refer to Lubrication System - "Engine Oil")
Fill the radiator with coolant.
(Refer to Cooling System - "Coolant")
