Disconnect the OTS and PCM connectors and inspect for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Reconnect the connectors.

Connect the GDS and go to ""Current Data"".

Monitor OTS value in Current Data, check and wiggle the harness(es), connector(s), and terminal(s).

Any change in the values indicates a poor connection. Was a connector problem found?

	▶ Repair the connector. Go to "Verification of Vehicle Repair" procedure.
	▶ Go to "Signal Circuit Inspection" procedure.

IG "OFF". Disconnect OTS connector.

IG "ON"

Measure voltage between signal terminal of OTS harness connector and chassis ground.

Is the measured voltage within specification ?

	▶ Go to " Component Inspection" procedure.
	▶ Repair short to ground in harness. Go to "Verification of Vehicle Repair" procedure.