Perform TEC Learning according to procedure.

- TEC Learning method

- TEC Learning will be completed with fuel cut in a range of over 2,000 rpm for more than 10 seconds.

Start the engine.

Operate the vehicle within Conditions for setting DTC in General Information.

Has the same DTC been found?

	▶ Go to"Visually check CKPS and target wheel" procedure.
	▶ Repair or replace as necessary. Go to"Verification of Vehicle Repair" procedure.

IG "OFF

Visually check to see if the CKPS is loose or target wheel is deformed or damaged.

Are the above items in normal operating condition?

	▶ Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "Verification of Vehicle Repair" procedure.
	▶ Repair or replace as necessary and then go to"Verification of Vehicle Repair" procedure.