Component Inspection
■ Check injector
1.

IG "OFF". Disconnect injector connector.

2.

Measure resistance between power and control terminals of injector connector.(Component side)

Specification : 13.8 ~ 15.2Ω [20℃(68℉)]

3.

Is the measured resistance within specification ?

▶ Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known - good injector and check for proper operation. If the problem is corrected, replace injector and go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика