Component Inspection
■ Check OCV resistance
1.

IG "OFF". Disconnect OCV and PCM connector.

2.

Measure resistance between power and signal terminals of OCV. (Component Side)

Specification : 9.4 ~10.4 [20℃(68℉)]

3.

Is the measured resistance within specification?

▶ Go to "OCV Actuation Test" as follows.

▶ Substitute with a known - good OCV and check for proper operation. If the problem is corrected, replace OCV and go to "Verification of Vehicle Repair" procedure.

■ OCV Actuation Test
4.

Connect GDS and IG "ON".

5.

Select "OIL CONTROL VALVE" on the Actuation Test.

6.

Activate "OIL CONTROL VALVE" by pressing "START" button.

(Should hear a faint click from Oil Control solenoid Valve)

7.

Repeat this procedure 4 or 5 times to ensure oil control solenoid valve reliability.

8.

Does OCV generate click sound during actuation test?

▶ Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known - good OCV and check for proper operation. If the problem is corrected, replace OCV and go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика