Component Inspection
■ Check VIS 2
1.

IG "OFF". Disconnect VIS 2 connector.

2.

Measure resistance between power and control terminals of VIS 2 connector.(Component side)

Specification : 30 ~ 35 Ω (22℃/71.6℉)

3.

Is the measured resistance within specification ?

▶ Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known - good VIS 2 and check for proper operation. If the problem is corrected, replace VIS 2 and go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика