DTC Analysis
■ DTC check
1.

Connect GDS.

2.

IG "ON".

3.

Select "SRSCM" system.

4.

Using a GDS, Check DTC present.

5.

Are any DTCs present ?

▶ If B1620(Internal fault-Replace SRSCM) is set, repair according to DTC diagonositic guide of SRSCM system. In a case of replacing the SRSCM, operate "longitudinal G sensor Calibration" by GDS. (DBC/HAC only, refer to C1285)

▶ If B1101(Battery Voltage High) is set or B1102(Battery Voltage Low) is set, repair according to DTC diagonositic guide of SRSCM system. In a case of replacing the SRSCM, operate "longitudinal G sensor Calibration" by GDS. (DBC/HAC only, refer to C1285)

▶ Go to next step.

Яндекс.Метрика