3.
Disconnect the back up lamp switch connector (A).
Set shift lever to N position.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
Disconnect the back up lamp switch connector (A).
Separate the control cable from the control shaft complete after remove the pin (A) and washer (B).
Remove the back up lamp switch (A).
Remove the control shaft complete (A).
Tightening torque: 9.8~11.8N.m (1.0~1.2kgf.m, 7.2~8.7lb-ft)
Removal is possible only on "N" position.
Install in the reverse order of removal.
When installing, set control shaft lever to neutral position.
When installing, apply the sealant as shown in the illustration.
Specified sealant : MS 721-40 or MS721-38
