4.
Remove the pressure hose (B) from the oil pump and the suction hose from the suction pipe (C).
Tightening torque:
53.9 ~ 63.7 N.m(5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft)
[Thata / R]
[Lamda]
Drain the power steering fluid.
Remove the drive belt.
(Refer to Engine Mechanical System - "Timing Chain")
Remove the pressure switch (A).
Remove the pressure hose (B) from the oil pump and the suction hose from the suction pipe (C).
Tightening torque:
53.9 ~ 63.7 N.m(5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft)
[Thata / R]
[Lamda]
Loosen the mounting bolts (A) and then remove the power steering pump.
Tightening torque:
[Thata / R]
16.7 ~ 25.5 N.m(1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
[Lamda]
34.3 ~ 49.0 N.m(3.5 ~ 5.0 kgf.m, 25.3 ~ 36.2 lb-ft)
[Thata / R]
[Lamda]
Installation is the reverse of the removal.
Installation is the reverse of the removal.
Be sure to connect between a tube and a hose as shown in the illustration.
Add power steering fluid to reservoir.
Bleed the power steering system.
(Refer to General Information - "Repair procedures(Air bleeding)")
