2.
Remove the engine mounting support bracket (A).
Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
Install the jack under the edge of lower oil pan to support the engine.
Put the rubber block between jack and oil pan to avoid damaging the oil pan.
Remove the engine mounting support bracket (A).
Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
Remove the engine mounting bracket (A).
Tightening torque :
63.7 ~ 83.3 N.m (6.5 ~ 8.5 kgf.m, 47.0 ~ 61.5 lb-ft)
Install in the reverse order of removal.
Remove the roll rod bracket (A).
Tightening torque
Bolts (B) :
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
Bolt (C) :
107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)
Install in the reverse order of removal.
Remove the upper roll rod bracket (A).
Tightening torque
Bolts (B) :
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
Bolt (C) :
107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)
Do not reuse the bolt C, which is special bolt coated with bond.
Install in the reverse order of removal.
Remove the air duct.
(Refer to Intake and Exhaust System - "Air Cleaner")
Remove the battery.
(Refer to Engine Electrical System - "Battery")
Remove the air cleaner assembly.
(Refer to Intake and Exhaust System - "Air Cleaner")
Remove the battery tray.
(Refer to Engine Electrical System - "Battery")
Remove the engine control module (ECM).
(Refer to Engine Control/Fuel System - "Engine Control Module (ECM)")
Install the jack under the transaxle to support it.
Remove the service cover (A).
Remove the transaxle mounting bolt (A).
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
Remove the transaxle mounting bracket (A).
Tightening torque :
63.7 ~ 83.3 N.m (6.5 ~ 8.5 kgf.m, 47.0 ~ 61.5 lb-ft)
Install in the reverse order of removal.
