2.
Drain the transfer oil after loosening the drain plug (A).
Change | |
Normal Use | Severe Use |
No service required | 120000 km (80000 miles) |
Severe driving conditions
Driving in dusty, rough roads
Drivng in mountains areas
Driving for patrol car, taxi, commercial car or vehicle towing
Driving over 170Km/h
* Transfer oil should be replaced if the transfer assembly is fall into the water.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
Drain the transfer oil after loosening the drain plug (A).
Install the drain plug with new gasket.
Tightening torque :
58.9~78.5N.m (6.0~8.0kgf.m, 43.4~57.9lb-ft)
Remove the oil filler plug (A).
Add new oil through the filler plug hole.
Standard oil : Hypoid gear oil API GL-5, SAE 75W/90 (SHELL SPIRAX X or equivalent)
Oil capacity :
Diesel 2.0 / 2.2, Gasoline 2.4: About 0.6 L (0.16 U.S.gal., 0.63 U.S.qt, 0.53 Imp.qt.)
Gasoline 3.5: About 0.68 L(0.18 U.S.gal, 0.72 U.S.qt, 0.60 lmp,qt)
Filled up to lower filler plug thread level.
Install the oil filler plug with new gasket.
Tightening torque :
39.2~58.8N.m (4.0~6.0kgf.m, 28.9~43.4lb-ft)
Install the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
