4.
Remove the installation bolt (B), and then vertically remove the sensor from the transaxle housing.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
Disconnect the crankshaft position sensor connector (A).
Remove the installation bolt (B), and then vertically remove the sensor from the transaxle housing.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Apply the engine oil to the O-ring.
Insert the sensor in the installation hole and be careful not to damage when installation.
Install in the reverse order of removal.
Crankshaft position sensor installation bolt:
6.9 ~ 9.8 N.m (0.7 ~ 1.0 kgf.m, 5.1 ~ 7.2 lb-ft)
