4.
Unscrew 3 mounting bolts (B) by using a allen wrench.
Turn the ignition switch OFF and disconnect the battery (-) cable.
Remove the turbo charger assembly.
(Refer to Engine Mechanical System - "Turbo Charger")
Remove the C - clip (A) from the rod fixing part by using a common driver.
Unscrew 3 mounting bolts (B) by using a allen wrench.
Remove the Electric VGT actuator (A).
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Installation is reverse of removal.
Electric VGT actuator installation bolt : 6.0 ~ 7.0 N.m (0.6 ~ 0.7kgf.m, 4.3 ~ 5.1 lb-ft)
