4.
Remove the LP-EGR DPS (B) after removing the bolt.
Turn the ignition switch off and disconnect the battery nagative (-) cable.
Disconnect the LP-EGR DPS connector.
Disconnect the LP-EGR differential hose (A).
Remove the LP-EGR DPS (B) after removing the bolt.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Install in the reverse order of removal.
LP-EGR differential pressure sensor installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
