3.
Disconnect the low pressure fuel quick-connector (A).
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”)
Turn the ignition switch OFF, and then remove battery (-) cable.
Disconnect the low pressure fuel quick-connector (A).
Disconnect the vapor hose (A) which is connected from the PCSV.
Lift the vehicle.
Remove the fuel tank.
(Refter to Fuel Delivery System - "Fuel Tank")
Open the fuel feed line fixing clip (A) to using driver.
Remove the installation bolt, and then releasing the under cover (A).
Disconnect the fuel & brake line protect (A) from the fixing clip.
Disconnect the fuel feed line fixing clip (A) from engine room lower.
Remove the fuel line.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Install in the reverse order of removal.
