1.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
caution
Be careful not to damage to the hub bolts when removing the front wheel and tire (A).
Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
Be careful not to damage to the hub bolts when removing the front wheel and tire (A).
Loosen the drain plug (A) and pull out the differential gear oil.
Tightening torque:
49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft)
Remove the rear driveshaft.
(Refer to Rear Driveshaft Assembly - "Rear DriveShaft")
Remove the propeller shaft.
(Refer to Propeller Shaft Assembly - "Propeller Shaft")
Remove cover (B) as loosen screw (A-4ea).
Disconnect the pressure sensor connector (A) and oil hydraulic motor connector (B).
Remove rear differentia assembly (B) as loosen mounting (A-4ea) after install jack
Tightening torque:
49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft)
After loosen the bolt and then remove the differential carrier (B) from the coupling (A).
Tightening torque:
56.9 ~ 64.7N.m (5.8 ~ 6.6kgf.m, 42.0~47.7lb-ft)
Install in the reverse order of removal.
Gear oil is injected.
Specified lubricant:
Hypoid gear oil API GL-5, SAE 75W/90 (SHELL SPIRAX X or equivalent)
Oil quantity :
Fill up to the bottom level of the filler plug hole (About 0.53L)
Check the rear alignment.
(Refer to Suspension System - "Rear Alignment")
