3.
Check glow plug for damage.
Never connect glow plug directly to car battery to test the heating performance of the glow plug. It causes damage to the glow plug.
Before removing glow plug to inspect it, be sure to check that glow plug fuse (in the engine compartment fuse & relay box) is properly connected in place. If starting the engine with the glow plug fuse improperly connected, it causes damage to the glow plug.
"Be sure to check that the engine coolant temperature is below 30°C prior to inspection. If the coolant temperature is above 30°C, incorrect resistance of the glow plug may be measured."
Check the continuity between the terminal and body as illustrated. Replace if discontinuity or with very small or large resistance.
Specification: Refer to "Specificatio" section.
State | Resistance |
Short | Below 100mΩ |
Open | Over 1Ω |
Remove oil from plug before measuring as glowplug resistance is very small.
Check for rust on glow plug plate.
Check glow plug for damage.
Turn the ignition switch OFF and disconnect the battery (-) cable.
Disconnect the harness extension connector (A).
Remove the harness mounting bolts (B), and then release the control harness (C).
Remove the mounting bolts (A) and disconnect the vacuum hose (B), and then release the fuel line (C).
Remove the mounting nuts (A), and then glow plate (B).
Remove the glow plug from the vehicle.
Install in the reverse order of removal.
