2.
Using a screwdriver or remover, remove the center fascia panel (A).
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Disconnect the negative (-) battery terminal.
Using a screwdriver or remover, remove the center fascia panel (A).
Remove the heater control unit connectors (A).
Remove the heater control unit (A) with hazard switch.
(Refer to HA group - "Heater & A/C Control Unit")
Install the heater control unit to the center fascia panel.
Install the center fascia panel.
It will be able to diagnose defects of IPM with GDS quickly. GDS can operates actuator forcefully, input/output value monitoring and self diagnosis.
Select "Current data", if you will check current data of hazard switch.
If you will check the hazard switch operation forcefully, select "Actuation test".
