3.
Disconnect the clutch switch connector (A).
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Pannel")
IG "OFF"
Disconnect the clutch switch connector (A).
IG "ON"
Measure the voltage between signal terminal of clutch switch harness connector and chassis ground.
Specification : 11.5V ~ 13.0V
Measure the voltage between ground terminal of clutch switch harness connector and chassis ground.
Specification : Continuity ( below 1.0Ω)
Remove the clutch switch.
(Refer to Clutch Switch - "Removal")
Push the clutch switch in the direction of the arrow to make sure that continuity is cut off.
Condition | Clutch Pedal pressed | Clutch Pedal Released |
Switch Operation | ON (below 1.0Ω ) | OFF ( Infinite Ω ) |
