5.
Remove the oil jet (A).
Use fender covers to avoid damaging painted surfaces.
To avoid damage, unplug the wiring connectors carefully while holding the connector portion.
Mark all wiring and hoses to avoid misconnection.
Turn the crankshaft pulley so that the No.1 piston is at top dead center.
Engine removal is required for this procedure.
In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair work right after engine stops.
Remove the balance shaft module.
(Refer to Lubrication System - "Balance Shaft Module")
Remove the ladder frame.
(Refer to Cylinder Block - "Ladder Frame")
Remove the piston & connecting rod assembly.
(Refer to Cylinder Block - "Piston And Connecting Rod")
Remove the crankshaft.
(Refer to Cylinder Block - "Crankshaft")
Remove the oil jet (A).
