3.
Install the SRSCM with the SRSCM mounting bolts.
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
note
Use new mounting bolts when replacing the SRSCM after a collision.
Remove the ignition key from the vehicle.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
Install the SRSCM with the SRSCM mounting bolts.
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Use new mounting bolts when replacing the SRSCM after a collision.
Connect the SRSCM harness connector.
Install the rear air vent duct and floor console.
(Refer to Body - "Floor console")
Reconnect the battery negative cable.
After installing the SRSCM, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
SRSCM is sensing the vehicle rollover. SAB, CAB, BPT will be able to expanse if mechanic moves the SRSCM on vehicle during IGN ON state. For this reason, turn the IGN OFF surely and then remove the SRSCM from vehicle.
If the SRSCM is replaced always perform variant coding. Also, perform the lateral G sensor 0 point setup. (Refer to Brake System – “Yaw-rate and Lateral G Sensor”)
