2.
Remove the lower anchor bolt. (Without EFD)
Remove the seat belt after pushing the lock pin (A). (With EFD)
Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work.
Remove the lower anchor bolt. (Without EFD)
Remove the seat belt after pushing the lock pin (A). (With EFD)
Remove the following parts. (Refer to the Body group- Seat belt)
Door scuff trim
Center pillar trim
Remove the upper anchor bolt.
Loosen the Seat Belt Pretensioner mounting bolt and remove the Seat Belt Pretensioner.
Disconnect the Seat Belt Pretensioner connector.
Remove the ignition key from the vehicle.
Disconnect the battery negative cable and wait for at least thirty seconds.
Connect the Seat Belt Pretensioner (BPT) connector.
Tightening torque
Bolt B: 39.2 ~ 53.9 Nm (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb.ft)
Install the Seat Belt Pretensioner (BPT) with a bolt.
Install the upper anchor bolts.
Tightening torque
: 39.2 ~ 53.9 Nm (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb.ft)
Install the following parts. . (Refer to the Body group- Seat belt)
Center pillar trim
Door scuff trim
Install the lower anchor bolts. (Without EFD)
Tightening torque
: 39.2 ~ 53.9 Nm (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb.ft)
Insert the seat belt to the EFD. (With EFD)
Reconnect the battery negative cable.
After installing the Seat Belt Pretensioner (BPT), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
