2.
Remove the seat belt after pushing the lock pin (A).
Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work.
Remove the seat belt after pushing the lock pin (A).
Remove the following parts. (Refer to the Body group-Interior trim)
Door scuff trim
Center pillar trim
Disconnect the EFD connector.
Loosen the EFD mounting bolt (B) and remove the EFD.
Remove ignition key from the vehicle.
Disconnect the negative (-) cable from battery and wait for at least thirty seconds.
Install the EFD with a bolt.
Tightening torque
: 39.2 ~ 53.9 Nm(4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
Connect the EFD connector.
Install the following parts. (Refer to the Body group - Interior trim)
Center pillar trim
Door scuff trim
Insert the seat belt to the EFD (A).
Make sure the lock pin is connected in properly.
Reconnect the battery negative cable.
After installing the EFD, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
