4.
Remove the clutch regulator (C) from the master cylinder after removing the pin (B).
note
●
When installing, Apply grease on a O-ring part of regulator connector.
●
Replace the O-ring with new when install the clutch regulator.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
The case of diesel vehicle, remove the fuel filter.
D 2.0 (Refer to Engine Control/Fuel System - "Fuel Filter")
D 2.2 (Refer to Engine Control/Fuel System - "Fuel Filter")
Remove the reservoir hose (A) from the clutch master cylinder.
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
Remove the clutch regulator (C) from the master cylinder after removing the pin (B).
When installing, Apply grease on a O-ring part of regulator connector.
Replace the O-ring with new when install the clutch regulator.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Pannel")
Disconnect the clutch switch connector (A) and ignition lock switch connector (B).
Loosen the clutch pedal mounting nuts (C) and bolt (D).
Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
Remove the clutch pedal assembly with master cylinder.
Separate the push rod (A) from the clutch pedal assembly after remove the pin and washer.
separate the master cylinder from the clutch pedal assembly after loosening the bolts (A).
Install in the reverse order of removal.
After be equipped, perform bleeding air procedure in concentric slave cylinder after pouring the brake fluid.
(Refer to Clutch System - "Concentric Slave Cylinder Assembly")
